After boot, M116 does not wait after G10

deckingman

@kuon I'd have thought that's probably normal. If you think about it, your G10 commands set the active and standby temperatures for two tools - P0 and P1 and those temperatures are different for each tool. So which of those temperatures should the M116 wait for? The answer is - whichever tool is selected / active. But until you send a "Tn" command, neither tool is selected. So the firmware has no idea which temperature that has been set with the two G10 commands, that M116 should wait for and furthermore, neither tool is active so until a tool is selected, nothing is being heated.

Suggest you put a T(n) command (where n is either 0 or 1 depending on which tool you want to stat heating), somewhere before the M116.

kuon

Actually you are right, this is because my initial issue is that M116 does not wait in my tpost0.g, I tried to reproduce a simple case and ended removing the tool change. But the following does not wait either:

M107
M190 S60
G10 P0 S220 R200
G10 P1 S240 R200
T0
G28

; tpost0.g
; called after tool 0 has been selected


M106 R2        ; restore print cooling fan
M116           ; wait for temperatures
M83            ; relative extrusion

; check that we are homed, this is to avoid error when we change tool while not homed
if move.axes[0].homed && move.axes[1].homed && move.axes[2].homed && move.axes[3].homed
  G1 R2 Z1 X0 F12000    ; go above position at 5mm
  G1 R2          ; dive back

; workaround for M302 not working with remove extruder
if heat.heaters[1].current > 190
  G1 E10 F1000    ; extrude 10mm

fcwilt

Did you verify that the tpost0.g file was actually called?

Or you can put the M116 in the file that sets T0 active.

Frederick

kuon

Actually I just assumed tpost0.g would be called. Is there a reason why it wouldn't? I can do more tests just right now because I am printing.

If I put M116 just between T0 and G28, it waits, but my actual issue was that I'd like T0 to wait by itself as there is an M116 in tpost0.g

jay_s_uk

@kuon tpostx.g will always get called.
Pre before the tool is selected, post after the tool selected.
You can confirm using debugging

kuon

@jay_s_uk said in After boot, M116 does not wait after G10:

@kuon tpostx.g will always get called.
Pre before the tool is selected, post after the tool selected.
You can confirm using debugging

That's what I assumed. So T0 should wait with M116 in it, right?

jay_s_uk

it should do, yes.
Maybe change your M116 to expicitly name the tool to wait for, i.e. M116 P0

deckingman

@kuon Well tpost happens after a tool has been used. That is to say, once a tool has been finished with and is no longer the active tool. Therefore, I would be surprised if M116 in tpost would wait (because the tool is finished with).

fcwilt

@kuon said in After boot, M116 does not wait after G10:

Actually I just assumed tpost0.g would be called.

Never assume - always verify.

In this case this may apply - from the docs:

If all axes have been homed, run macro tpost#.g where # is the number of the new tool.

Since you are following the T0 with G28 that suggests they axes may NOT be homed.

Frederick

jay_s_uk

@deckingman don't you mean tfree?
I think the definitions of the tool change files here are clear
https://duet3d.dozuki.com/Wiki/Macros#Section_Tool_change