Cannot see endstops in Machine Specific
PaulHew last edited by
Just getting things plugged in.
Just plugged one of my endstops in and I cannot see it on Machine Specific page to test it, it list no endstop section.
; Endstops M574 X1 S1 P"io5.in" ; configure active-high endstop for low end on X via pin io5.in M574 Y1 S1 P"20.io1.in" ; configure active-high endstop for low end on Y via pin 20.io1.in
X is connected only at the moment, waiting for a resistor for the Can bus
Have I missed something?
Not available there at the moment in 3.2 but in 3.3 it makes a comeback as a plugin.
Or there's always M119