PanelDue is flashing and Says "Connecting"
-
@pete1961 said in PanelDue is flashing and Says "Connecting":
I have the larger Panel Due from about 4 years ago. If there is a model code you need I would have to remove it from the front of my printer to pull any further information.
Is it the integrated version, or does the controller board plug on to the back of the display?
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@pete1961 said in PanelDue is flashing and Says "Connecting":
What is know is when I use a Mac I can connect with serial tool
When you connect with serial tools does it respond to commands? If you send M552 does it respond with an IP address? Can you ping that IP address or connect to it in your browser?
-
@dc42
It has he controller board plugged into the back of it. -
@phaedrux
Cannot ping the address.
Will not accept any M Code Commands. -
Does the Duet show up in device manager? Have you tried the firmware erase and reflash with bossa instructions yet?
-
@phaedrux
A working COM port with no errors shows up in the Device Manager when connected via. USB Cable.Are there instructions on how to re-flash with BOSSA?
Haven't used this method in a number of years. -
@pete1961 said in PanelDue is flashing and Says "Connecting":
Are there instructions on how to re-flash with BOSSA?
Haven't used this method in a number of years.Yes, see here: https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware
-
@phaedrux
Making progress.
Re-installed firmware with Bossa. Might not have been necessary because now I can connect via. wifi with Duet Web Control and print normally.
The Panel Due however does not really accept any touch screen input. It does not show any real time information like temperatures either. When I try to access any SD Card it says "Files on Card 0".
I'm thinking something is wrong with the panel due.
I can access 3D Print Files on the card of course and DWC sees all files as well.
Any thoughts??? -
Now that you can connect via DWC, can you send M122 and M98 P"config.g" and post the results here?
Can you also provide your full config.g?
What firmware version is on the duet and the paneldue?
-
@phaedrux
I just re-flashed the panel due firmware and now have it working as well.
So I think I'm good.
I will be back if I continue with a problem.
THANKS for your help!
