Yes a better cable is in order with the 10" cable I fabricated the errors are more spurious than previously but still around.
The cabling is obviously the cause of this problem.
Latest posts made by pete1961
-
RE: Error Parsing Response
-
RE: Error Parsing Response
I'm going to say at present after making a shorter cable from scratch the errors have stopped.
I went from about a 24" cable down to a 10" Cable.
I will come back here if I see more errors. -
RE: Error Parsing Response
@dc42
I just received a brand new panel due to upgrade an old one.
The new 7i causes these errors.
The old panel with extra board that plugged into it probably is 5 years old works fine.
I'm running the latest stable release of the duet firmware and also the current latest firmware for the panel 7i.Any idea why this is causing me grief?
Considering returning the PanelDue as I believe something is wrong with it if the old PanelDue works fine.Anything you recommend???
-
Duet WIFI Bed Heater with SSR on Bed Heat Output Doesn't Work.
I have a known good DCDC Solid State Relay that I'm not able to trigger on the Bed Output of theDuet WIFI Board. I used to use a Auto Relay which was fine as a bang-bang relay. I want more precise heat control on the bed so switching to an SSR was what I tried to do.
Would anyone know why the 12V Bed Heat Output on the board will not power the relay???
-
RE: PanelDue is flashing and Says "Connecting"
@phaedrux
I just re-flashed the panel due firmware and now have it working as well.
So I think I'm good.
I will be back if I continue with a problem.
THANKS for your help! -
RE: PanelDue is flashing and Says "Connecting"
@phaedrux
Making progress.
Re-installed firmware with Bossa. Might not have been necessary because now I can connect via. wifi with Duet Web Control and print normally.
The Panel Due however does not really accept any touch screen input. It does not show any real time information like temperatures either. When I try to access any SD Card it says "Files on Card 0".
I'm thinking something is wrong with the panel due.
I can access 3D Print Files on the card of course and DWC sees all files as well.
Any thoughts??? -
RE: PanelDue is flashing and Says "Connecting"
@phaedrux
A working COM port with no errors shows up in the Device Manager when connected via. USB Cable.Are there instructions on how to re-flash with BOSSA?
Haven't used this method in a number of years. -
RE: PanelDue is flashing and Says "Connecting"
@phaedrux
Cannot ping the address.
Will not accept any M Code Commands. -
RE: PanelDue is flashing and Says "Connecting"
@dc42
It has he controller board plugged into the back of it. -
RE: PanelDue is flashing and Says "Connecting"
I have the larger Panel Due from about 4 years ago. If there is a model code you need I would have to remove it from the front of my printer to pull any further information.