Small UI BUG
Hi. I just noticed this today. THe DWC analize the loaded gcode and give this information in the JOB INFORMATION section:
Height: 400.00 mm
Layer Height: 0.20 mm
Filament Usage: 9203.90 mm
Height is reported as 400mm, but the print has only 9 mm tall. There is a G1 Z400 at the end of the end gcode, and the DWC is reading it as if this is part of the model. Suggestion would be that this analisys should be done TILL the end gcode, so this gcodes are not taken into account.
fcwilt last edited by
jay_s_uk last edited by
@tinchus which version of RRF and DWC are you running?
cosmowave last edited by cosmowave
@tinchus I think you can solve the problem with putting an ";E" after the comment semi-colon, like this:
G1 Z400 ;E drop the print bed (E to exclude from layer count)
(Obviously, you need to be in absolute positioning mode for this to work)
@fcwilt this command is part of my custom END GCODE
@jay_s_uk Version 3.3.0
@cosmowave This solved "the issue". I didnt knew about the "E" command