Destroyed my frimware
-
After sending M997 S1, did you get any progress messages on PanelDue prior to the "comm write error" one?
-
it tryed to conect with different baudrates but all faild
-
it tryed to conect with different baudrates but all faild
Try it a few more times, with just USB power applied, and also with VIN power applied. If it always fails to connect at all the baud rates it tries, ask your supplier to repair or replace the Duet.
-
so frimeware update killed the DUET ?
is there a way to get a clean SD card image? something like all files you ship the sd card with.by the way I bought the DUET here.
-
The firmware update won't have killed the Duet however something else is going on.
Can you confirm
- With nothing plugged in other than the USB cable you can connect to the Duet over USB using pronterface/Repetier?
- What happends when you send M997 S1 when connected over USB
-
- I do print with repetier host at the moment
- when only Powerd by USB I typed M997 S1 via Paneldue got the error massage "Error: instalation failed due to comm write error" on the paneldue
when I conect whit repetier host I first get ERROR : Failed to initialise WIFI module code -10
then typed M997 S1 and got back "Error: instalation failed due to comm write error". it starts at Baud 460800 then 230400 -> 115200 -> 74880
with 5 V and 24V enable and no USB i got the same play
-
Try it without the panel due plugged in please
-
same
-
What revision PCB is it: 1.0, 1.01 or 1.02; and when did you buy it?
-
I think it is 1.0
I bought it late last year
