BLtoch trigger event for sanity check

semi55

@engikeneer Thanks for your comment, sry I did not mention that I’ve already setup the BLtouch as Z-probe.

I've tested your recommendation.
First, I’ve tested the code for the "zProbeAsEndstop" object model:

This is my test macro:

G91               		;relative positioning

M564 H0						;allow movement without homing
G1 H2 Y-15 X15 F10000   ;lift y relative to current position


M401 					;deploy probe
G1 H1 Y-285 F2400 		;move Y down until BLTouch is triggered

;check status of Bltouch
if sensors.endstops[1].triggered == true								

	M291 P{" Probe triggered"} S1
	G1 Y4 F30000 			;Backoff 3mm
else
	M291 P{" Not recognized"} S1
	G1 Y4 F30000 			;Backoff 3mm

Second test was the probe value itself:

This is the second test macro:

G91               		;relative positioning

M564 H0						;allow movement without homing
G1 H2 Y-15 X15 F10000   ;lift y relative to current position


M401 					;deploy probe
G1 H1 Y-285 F2400 		;move Y down until BLTouch is triggered

;check status of Bltouch
if sensors.probes[0].value[0] > 0								

	M291 P{" Probe triggered"} S1
	G1 Y4 F30000 			;Backoff 3mm
else
	M291 P{" Not recognized"} S1
	G1 Y4 F30000 			;Backoff 3mm

Unfortunately, I always get "Not recognized" as message

fcwilt

@semi55

Hi,

Why a BLTouch instead of, say, a microswitch?

Frederick

semi55

@fcwilt because I use the BLtouch also for leveling purposes and I want to make use of this sensor as it is already mounted on the tool.

fcwilt

@semi55 said in BLtoch trigger event for sanity check:

@fcwilt because I use the BLtouch also for leveling purposes and I want to make use of this sensor as it is already mounted on the tool.

If you are using it for leveling purposes how will it trigger when moving the Y axis?

Frederick

semi55

@fcwilt I am using it on a belt printer with a tilted 45 degree axis, so the leveling happens on the Y-Axis

fcwilt

@semi55 said in BLtoch trigger event for sanity check:

@fcwilt I am using it on a belt printer with a tilted 45 degree axis

Interesting.

brainiac27

@semi55 I'm having the same problem with the probe value. After a major crash, putting together a BlTouch self-check macro. No matter what, I can't get the value to change unless the BlTouch is in the alarm mode.

fcwilt

@brainiac27 said in BLtoch trigger event for sanity check:

@semi55 I'm having the same problem with the probe value. After a major crash, putting together a BlTouch self-check macro. No matter what, I can't get the value to change unless the BlTouch is in the alarm mode.

The value is changing but you are likely not going to be able to catch that change as it is quickly cleared.

Frederick

semi55

@brainiac27 That is exactly what I've done right now as a work around. I let the BLtouch enter the alarm mode and use that as a trigger event for further commands.

brainiac27

@fcwilt Thanks for pointing that out, I now see how the probe value blips during a mesh level. Now I just check that the value is 0 before and after running a BlTouch self test for a couple seconds. Already saved my hide once while I figure out my intermittent issue.