Curiosity about temperature calibration
peirof last edited by
Its a curiosity..
When you adjust the temperature control... DUET goes through a series of phases....
What does it do in each phase? in the console, there is a small description, but from some phase nothing comes out, in mine in phase 2 of the calibration of the bed.
PHASE 1 - Heater on
PHASE 2 - nothing showed
PHASE 3 - Heating system settings
PHASE 4 - Heating with fan off... Bed?
After this, report, and M500
jens55 last edited by
@peirof, there is also a phase 5 with the part cooling fan on if you are calibrating tools instead of a heater (using the T option rather than the H option)