PENDANT ONLY SEND THE M112
-
Hello
My problem is that my pendant (the same as david's, with an arduino micro) only sends the M112 command, but does not perform any movement via the encoder. My hardware is a DUET3 6HC with SBC and without Panel DUE, Configuration CNC. The arduino sketch was uploaded with firmware 1.8.1 thank you for your help
-
@madedi123 have you seen this thread:
https://forum.duet3d.com/topic/24873/cnc-pendant-disconnecting-duet/10?_=1635943175415how do you know its sending M112?
I am not sure if this has been tested with an SBC mode machine (although it should work as its doing the same as a PanelDue basically).
-
i can read it on dwc console, but nothing when i turn the encoder?
-
do you know if i have to configure something in davids ino file from github ?
