please help me blv setting
-
depends on where your thermistor sits. But going 90C is still wrong. I would suggest to let the bed soak for 10-15min at 60C then try again.
-
@oliof ok
-
Don't forget to reslice with adjusted bed heat settings.
-
@oliof yes but that has nothing to do with the quality of the piece if
-
Let's solve one problem at a time. I you don't have proper adhesion, the rest of the print will always look bad no matter what. So that needs fixing first.
<>RatRig V-Minion Fly Super5Pro RRF<> V-Core 3.1 IDEX k*****r <> RatRig V-Minion SKR 2 Marlin<>
-
@oliof yes ok thank you
-
@oliof
I put new pei my ca does not adhere to 60 degrees -
@oliof
as the aluminum plate is 10mm I have to heat for 30 minutes to 60 after it holds -
@sgk that's quite possible. If you let the print bed soak the heat, does the print adhere better? Show us a new photo.
To speed up printing, I suggest a simple 30mm cube in vase mode.
-
@oliof hello I tried to print more than once at 60d but the cubes end up taking off I must put in mini 80d.
I put a new pei sheet and the same ideas? -
Since 80C is way above PLA glass transition temperature, your thermistor configuration may be wrong Please confirm what kind of thermistor you bought for this build.
Alternately, the thermistor ADC may need calibration.
you're saying you can print a vase mode cube with the bed at 80C -- can we get a photo of that?
<>RatRig V-Minion Fly Super5Pro RRF<> V-Core 3.1 IDEX k*****r <> RatRig V-Minion SKR 2 Marlin<>
-
@oliof
good morning, how are you doing? yes ok -
-
@oliof the bed
-
@sgk
-
@sgk and i have this error too
-
@sgk
-
still looks slightly hot on the bed surface. and you either have z banding from a z drive that's not straight, and/or banding like artifacts from a bed heater that's not PID tuned.
-
(also it doesn't look like a single wall vase mode print)
<>RatRig V-Minion Fly Super5Pro RRF<> V-Core 3.1 IDEX k*****r <> RatRig V-Minion SKR 2 Marlin<>
-
@oliof
the bottom part it's just that I didn't turn on the fan
