Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

If I'm not using heaters or stepper motors...

General Discussion

2

3

111

Log in to reply

undefined

Nightowl
last edited by

...with the USB supply be adequate to power my Duet2 network board?

I hope to be using it to control something in the future, so I only really want to use it to test stuff for my own learning curve.

Thanks
Few things are more dangerous than taking the advice of someone who thinks he knows what he's doing.
I'm still on my learning curve, so take everything I say with caution!

RatRig 1075, Duet3 MB6HC, Sorotec SFM 1000 PV-ER milling motor, Hobbyist
undefined 1 Reply Last reply
Reply Quote 0
undefined

T3P3Tony administrators @Nightowl
last edited by

@Nightowl yes if you have no other 5V loads on it. Maybe if you have 5V loads, depending on how much you plug in.
www.duet3d.com
undefined 1 Reply Last reply
Reply Quote 1
undefined

Nightowl @T3P3Tony
last edited by

Thank you, @T3P3Tony
Few things are more dangerous than taking the advice of someone who thinks he knows what he's doing.
I'm still on my learning curve, so take everything I say with caution!

RatRig 1075, Duet3 MB6HC, Sorotec SFM 1000 PV-ER milling motor, Hobbyist
1 Reply Last reply
Reply Quote 0

1 / 1