Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Inconsistent track width

    Scheduled Pinned Locked Moved
    Hardware wishlist
    2
    5
    929
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Avamanderundefined
      Avamander
      last edited by

      Is this inconsistency intended on the old 0.8.5 board (screenshot of Duet0.85.brd)?

      1 Reply Last reply Reply Quote 0
      • T3P3Tonyundefined
        T3P3Tony administrators
        last edited by

        Woops, that's an error in the old board design. Is it in the Gerbers as well?

        Have a go with fitting it all into 3 layers. TBH I never considered a 3 layer board as that's pretty non standard. You need a good ground plane though.

        May I ask what your plans are?

        www.duet3d.com

        1 Reply Last reply Reply Quote 0
        • Avamanderundefined
          Avamander
          last edited by

          Is it in the Gerbers as well?
          Haven't checked.

          May I ask what your plans are?
          Just thought for a moment about rolling with my own board, because paying more than a 2 hundred $ just sounded too steep for me so I was looking at if I could save some cost. Adding it all up (including time I'd have to spend to learn how to redesign the board to 3(or even more extreme 2)-layers without errors) I realized it's not worth it.

          EDIT: Clarified my sentence

          1 Reply Last reply Reply Quote 0
          • T3P3Tonyundefined
            T3P3Tony administrators
            last edited by

            Fair enough

            I would be pretty surprised if anyone managed to make it fit on 2 layers. Also that would remove the ground plane which would be a bad idea.

            www.duet3d.com

            1 Reply Last reply Reply Quote 0
            • Avamanderundefined
              Avamander
              last edited by

              @T3P3Tony:

              Fair enough

              I would be pretty surprised if anyone managed to make it fit on 2 layers. Also that would remove the ground plane which would be a bad idea.

              Would most likely mean just quite a "few" 0ohm resistors and a larger sized board (which isn't bad in terms of heat dissipation though).

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA