eSwitch mount for Duet Wifi (for Berd Air system)
-
Hi,
I wanted to share with you a design I've made to install the eSwitch board from Makerhive onto the Duet Wifi. I've search a way to carry the board on my printer while installing the Berd Air system, I finally ended up by designing this mount.
It plugs in an IDC connector and was designed to coexist with a PT100 daughter board
Here's the link : https://www.thingiverse.com/thing:2879778
Hope it'll help few guys around here.
-
Sweet! Thank you. I'll print one up and try it out.
-
Very clever design, thanks!
-
Note : If you make terrible bridges just add support, but only for the bottom plane, groove slots are made with a 45 degrees angle so no bridge are required since it's not an extrem overhang.
