Duetwifi and paneldue 7“
-
Hi
I Build an hypercube 300x 300 with an different Z axis and have tested now some Hardware
Smoothieboard Rads 1.5 and now the duet wifi ,.
I use 0.9 degreees Steppers and it works Fine ( i just Need to tweak the sensorless Homing )
But the 7“ Panel is Lightning but Shows nothing
I found somewhere a hin5 That they ned same Speed 56700 ok granted
Question 1
Where do i find the Info how to verify that ?
Q2
Is there a way to get Both up to 25000 ?
Q3
Do others have Same issue ?Thx in advance
Thomas -
Is the screen showing the buttons etc. But stuck at status "Connecting", or is it blank? Or something else?
-
Wow that is fast
It Shows just a Kind of dark screen backlithed
So i use Pronterface to kick the wlan on and Then i use the Web Browser ...That is why i think no handshake and all Pixels Are in Same State
Thx
Thomas -
Even if it is not connected to a Duet, PanelDue should display the printer status screen (without real values of course) if it is supplied with power. So I suspect that either it was not programmed, or the Erase button has been pressed. You can try uploading firmware to it if you wish, see the installation instructions page.
-
Ok
I am Roaming Next dass but Then i search for the Article how to Flash the Panel
And respond success or failure
Thx
Thomas -
Hello
I now feel a little dumb because i found https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware which i s quite clear but i didn't find how to flash the panel due ? I have a lot of Arduino experience i do programs Granite devises Delta Servos so i have a good chance to achieve it but somehow i didn't find the panel please push me to the right direction thx thomas -
No idea if there is some other source but I referred to https://miscsolutions.wordpress.com/paneldue/ when updateing the PanelDue FW...
-
Yes, see the link that Alex provided. For the 7.0 integrated version, use file PanelDue-v3-7.0i.bin from https://github.com/dc42/PanelDueFirmware/releases/tag/1.20.
