Estrange behaviour



  • Hi,

    This morning I have try Print... I have to say that since some days without Zprobe... With manual calibration.

    After some sucesfull prints this morning I cant Print.

    1 Load filament
    2 Homing.
    3 Manual calibration.
    4 start Print... But, when printer reach, bed and, nozzle, temperatures... Printer Go to start position for print... And un load filament...

    Some ideas I can do?

    Slicer issue?



  • Sounds like your slicer is not setup for relative extrusion (M83)?



  • Thanks... Later try...


Locked
 

Looks like your connection to Duet3D was lost, please wait while we try to reconnect.