Jerk setting Maestro?
-
Hey people. Where are the jerk settings in the code? Sorry for such a Noobs question, this board is very new to me.
-
Jerk settings are found in the config.g file: https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCartesianPrinter
No need to edit the firmware like Marlin!
-
@cabal2000 M566 is the command you are looking for https://duet3d.dozuki.com/Wiki/GCode#Section_M566_Set_allowable_instantaneous_speed_change
In RepRap firmware, it is correctly referred to as "instantaneous speed change" rather than the very misleading term "jerk" that is widely used in 3D printing.
