Unable to connect to duet via Wifi
I have been using my duet for a while and it has been working well,
Today am just unable to connect to it, it has been a few weeks since I ran the machine.
When I run the windows diagnostic it gives the following error image url)
Any suggestions ?
Which firmware versions is your Duet using?
Here are some possible reasons:
- IP address conflict. Check that you can ping 192.168.1.11 when the Duet is powered, but not when it isn't powered.
- SD card problem (although recent firmware versions will return an error page to the browser in this case)
- Low WiFi signal strength. Check it by sending M122 from USB and looking at the report.
Sorry for a very late reply , was held up with other work.
There doesn't seem to be an IP conflit, I checked with the router.
And the SD happens to be relatively new.
I tried the M122 command on YAT
=== Diagnostics ===<LF>RepRapFirmware for Duet 2 WiFi/Ethernet version 2.02RC6(RTOS) running on Duet WiFi 1.02 or later<LF>Board ID: 08DGM-9T6BU-FG3S8-6J1FA-3SJ6Q-9BLZG<LF>Used output buffers: 1 of 20 (1 max)<LF>=== RTOS ===<LF>Static ram: 25524<LF>Dynamic ram: 98444 of which 0 recycled<LF>Exception stack ram used: 256<LF>Never used ram: 6848<LF>Tasks: NETWORK(ready,1444) HEAT(blocked,1232) MAIN(running,3860) IDLE(ready,200)<LF>Owned mutexes:<LF>=== Platform ===<LF>Last reset 00:04:50 ago, cause: power up<LF>Last software reset at 2019-01-02 11:37, reason: User, spinning module GCodes, available RAM 6548 bytes (slot 0)<LF>Software reset code 0x0003 HFSR 0x00000000 CFSR 0x00000000 ICSR 0x0441f000 BFAR 0xe000ed38 SP 0xffffffff Task 0x4e49414d<LF>Error status: 0<LF>Free file entries: 10<LF>SD card 0 detected, interface speed: 20.0MBytes/sec<LF>SD card longest block write time: 0.0ms, max retries 0<LF>MCU temperature: min 36.3, current 41.4, max 41.5<LF>Supply voltage: min 0.4, current 1.7, max 1.8, under voltage events: 0, over voltage events: 0, <Warning: Maximal number of bytes per line exceeded! Check the end-of-line settings or increase the limit in the advanced terminal settings.>
I am not able to make complete sense of it.
Any help is much appreciated.
If in YAT you go to Settings/Text Settings and change the line ending to <LF>, it will be easier to read the output.
Thank you !!
After reading the diagnostics from M122 I understood that the IP address has changed from.
192.168.1.11 to 192.168.1.16
Is there any way to stop that from happening ?.
I am also planning to run a 1 week print for a client, would it be better to run via WiFi or USB?.
You can reserve the IP address on your router with a DHCP reservation preferably.