I have been working with bl touch sensors for quite a while now and am quite un-happy them, when they work they work fine. The problem is 1 in every 5 probing cycles fail. I need to restart the machine a few times before getting the probing to work accurately again. I have bought 10 bl touch sensors out of which around 6 have this problem. I was using these on the MKS gen 1.4

Looking for new bed leveling sensors, definitely interested if someone can give a comparison or review of the ir sensor

Thank you all for your replies !

Will look into these !

Hi all,

I was wondering what the term interpolated to x256 meant when configuring my stepper drivers.

I am using x16 microstepping. I curious to know what the effects of this are.

Is it equivalent to x256 microstepping ? .

If interpolation is on will it draw more current for motors, or will there be any torque reduction due to this ?

Thanks
Hussain

Thanks for the reply,

Does the duet support any other touch screen apart from the panel due.

Or is the UI on panel due modifiable ?

Regards,
Hussain

Hi all,

Would like to know if the duet wifi supports the MKS mini LCD panel or any other LCD panel like Full graphics controller, etc.

Its just a economical option, and has front sd card loading which I find more convenient.

Thanks
Hussain.

I feel it has definitely improved by a large extent, will try calibrating e steps again.

It was mentioned somewhere that e-steps need to be whole numbers and not fractions, is that true ?

I have built a custom machine that had ripples on the surface using an MKS gen 1.4 board, Once I changed the board to Duet It was eliminated.

Wondering what the reason could be ?

above picture is before changing.

@agniusm Thanks I had the rippling on my MKS board , when I changed to duet it got eliminated.

Any Idea what the reason behind this could be ?

@agniusm Hi,

Any update on this ?

@bearer okay, will go through the wiring's again and also upload the config files ...