I came down and saw that my bl touch was flashing and printer just stopped mid print. Now i cannot get it to connect to wifi. Red and green keep blinking but stops for a few seconds and the red led by it self blink a few times then they are back to flashing. What could have happend? Running it on USB red and green are solid and i can connect through wifi.
(red +5V and green +3.3V, RED Diag and the RED Z step ones that were flashing, even the red Status LED which flashes during normal operation is also blinking.)
for your reference I am attaching a video here
https://drive.google.com/file/d/1kkoPCg-omT5udKRZ6X7b_BVSxWJLvX7k/view?usp=sharinglink text

@rushmere3d Thank you so-so much!!! This code is working now:)

@rushmere3d I was calibrating my tools when the bed collided with the z- probe sensor, causing it to display 1000. I replaced the Z- probe sensor, but it still displayed 1000.
Yes, when I press the switch, it returns to 0.

@rushmere3d I'm currently using Reprap version 3.4.1. It was working properly until the day before yesterday, when it encountered an error and displayed z-probe to 1000. I was surprised to see that even after unplugging the wire, it still showed 1000.

Hello, I'm having a problem with my E3D tool changer's z-probe sensor, which is stuck at 1000. I also tried switching from IO to I1 and changing the wiring section, but nothing changed; it remained at 1000. I updated the reprap firmware to check and modify again, but the z-probe 1000 remained. I'd appreciate it if you could assist me with this. Thank you for your consideration! Raj, Ritik
*Herewith I'm attaching the image of my config.g and the Z-probe(web interface)!
!

@phaedrux Thank you for your response but can you please elaborate this!

Hello, I'm having a problem with my E3D tool changer's z-probe sensor, which is stuck at 1000. I also tried switching from IO to I1 and changing the wiring section, but nothing changed; it remained at 1000. I updated the reprap firmware to check and modify again, but the z-probe 1000 remained. I'd appreciate it if you could assist me with this. Thank you for your consideration! Raj, Ritik
*Herewith I'm attaching the image of my config.g and the Z-probe(web interface)!