Bonjour,
---------------------------------------------------------------------------------------------------------------------------------------------------voilà je suis nouveau sur le forum et je viens d’acheter un duet 2 Wifi, après plusieurs utilisations tout s’est bien passé jusqu’au moment où j’ai eu une trace d’échauffement au niveau de la prise de mon plateau chauffant. Un peu de fumé est apparu au niveau de la connexion des fils , je mets en cause les paramètres du fichier config.g. De plus mon bed est connecté directement au duet et non au hcb, j'ajoutes un extrait de mon fichier config.g. Pouvez-vous m’éclairer sur ce sujet merci par avance.
Hello, here I am new on the forum and I have just bought a duet 2 Wifi, after several uses everything went well until the moment when I had a trace of overheating at the level of the socket of my heating plate. A little smoke appeared at the level of the connection of the wires, I question the parameters of the config.g file. Moreover my bed is connected directly to the duet and not to the hcb, I add an extract from my config.g file. Can you enlighten me on this subject thank you in advance.
Printer instamsys funmat, bed 260 x 260 . Température maximum 160°c
; Heaters
M308 S0 P"bedtemp" Y"thermistor" T122000 B3590 ; configure sensor 0 as thermistor on pin bedtemp
M950 H0 C"bedheat" T0 ; create bed heater output on bedheat and map it to sensor 0
M307 H0 B1 S1.00 ; enable bang-bang mode for the bed heater and set PWM limit
M140 H0 ; map heated bed to heater 0
M143 H0 S160 ; set temperature limit for heater 0 to 160C
M308 S1 P"e0temp" Y"thermistor" T100000 B4138 ; configure sensor 1 as thermistor on pin e0temp
M950 H1 C"e0heat" T1 ; create nozzle heater output on e0heat and map it to sensor 1
M307 H1 B0 S1.00 ; disable bang-bang mode for heater and set PWM limit
M143 H1 S450 ; set temperature limit for heater 1 to 450C
M308 S2 P"e1temp" Y"thermistor" T100000 B4138 ; configure sensor 2 as thermistor on pin e1temp
M950 H2 C"e1heat" T2 ; create chamber heater output on e1heat and map it to sensor 2
M307 H2 B1 S1.00 ; enable bang-bang mode for the chamber heater and set PWM limit
M141 H2 ; map chamber to heater 2
M143 H2 S120 ; set temperature limit for heater 2 to 120C