@Phaedrux i thought i did, but i just did it again and it worked
Best posts made by zecreton
-
RE: motor not moving
Latest posts made by zecreton
-
RE: No movement with any command
@dc42 do you think there is a person i could pay to come see it irl and fix the problem?
-
RE: No movement with any command
@dc42 M17 and M18 don't change anything, the rotor stays locked even with the ena disconnected
-
RE: No movement with any command
@droftarts yes the x position does show the change
-
RE: No movement with any command
@Phaedrux it is in the active enable position
-
RE: No movement with any command
You have used an upper case letter 'o' for the P parameter, it should be a zero
0
. Did it not report an error? Should be:
M569 P0 R1
Ian
i made an error in the message but i did send M569 P0 R1, sorry
-
RE: No movement with any command
@Phaedrux yea,i get the same thing on the driver side
-
RE: No movement with any command
@Phaedrux i can see a 5v signal when no command is sent, but it drops to 0v when i send a signal, is that normal?