@Phaedrux i thought i did, but i just did it again and it worked

@dc42 can i have an answer please?

@dc42 do you think there is a person i could pay to come see it irl and fix the problem?

@dc42 yea, i don't see any changes

@dc42 M17 and M18 don't change anything, the rotor stays locked even with the ena disconnected

@droftarts yes the x position does show the change

@Phaedrux it is in the active enable position

@droftarts

You have used an upper case letter 'o' for the P parameter, it should be a zero 0. Did it not report an error? Should be:
M569 P0 R1

Ian

i made an error in the message but i did send M569 P0 R1, sorry

@Phaedrux M569 PO R1

@Phaedrux yea,i get the same thing on the driver side

@Phaedrux i can see a 5v signal when no command is sent, but it drops to 0v when i send a signal, is that normal?