Hello,

I just experienced a mid-print failure associated with the message:

"Connection interrupted, attempting to reconnect...
DCS has been stopped"

My print was ~30% complete when this occurred, but the printer state was as if the print completed successfully: on the Job > Status page it had the option for Print Again, and the heaters were turned off. I checked the GCODE file and it looks fine, i.e. there is a full file worth of GCODE.

For context, I am running:

• Duet 3 MB6HC on SBC mode with Raspberry Pi 5
• Duet 3 Expansion Board 3HC
• Version 3.5.3 (stable) for each of the DWC, DSF, and MB6HC & EXP3HC boards

There is another thread from 4 years ago with the same issue but it seems it was marked as resolved with a new firmware revision.

I am now trying the print again now to see if I can replicate the behavior.