That fixed it!!!! I was entering it from the G-code line. Not on the config. Thank you

@dc42 @PHAEDRUX Im confused as to why I am getting and A&B phasing error on my DWC when i try to home Y. config.g Where am I going wrong?? I am using the M584 X0 Y6 Z2 E5 command.

@dc42 ok, I send M569 P5 R1 and set it to Active High. It works normal, I turn the machine off and on and it reverts back to Active Low. I even used the M500 command. it will not keep it in active high for P5

@dc42 swapping the wires worked, I added the R1 to the code but it didn't work so I swapped the wires. Still confused, but at least it is working now. Thank you. How do we fix the M569 code string?

@dc42 ok, disconnected the enable + & -. Now it works like it is supposed to. Why is this happening?

@dc42 ok, how do we fix the error? also, i disconnected the enable wires and it now turns CW when extrude or retract is activated.

@dc42 @Phaedrux I restarted the controller and checked the M569 and this it what it said. but, the motor is still in lock mode

@dc42 @Phaedrux the external motor is locked when you power up the board before activating that Extruder. So what is the next step?

@dc42 @phaedrux Sorry to be a bother, but, It takes the M569 command till you reset the firmware, ie.. shut off and back on. Then it goes back to original settings.

@dc42 @phaedrux it will not allow up date to active high setting either. Im very confused why it will not change settings??? I set the R to 1 as it says in the wiki, M569 P5 R1 T2.5:2.5:5.0 and it does't change anything. 0_1559665353230_M569-2.JPG