Thanks for the tip, here is a better picture.

I just tried to jump it with a wire just to test it and I still did not get any lights or response.

Hope this picture is good enough because my phones camera isn't the greatest at a close up pictures if not I can try and find my camera.

I'm guessing that would also stop it from send a response back to the duet when should trigger the z stop, is that correct?

Not at all especially not from I was testing to the following day when it stopped working. It just weird.

Looking at it again you are correct. There is an outline and solder on L1 but no component.

On one side of L1 it reads 3.3v and on the other about 58mv and across C3 I read about 58mv as well.

Oh sorry, here it is naked. Lol

It was purchased on 2/1/2024 from printed solid. I just took it apart and only the connection to the duet board and still same results. Here are the pictures of it.

I sent the command and it did not flash at all. I had tried that earlier as well but got no LED response but in the console it looks like it was successful.