Posts made by vmog23

Thanks for the follow-up. The one picture was taken before and one after but I just held the wire on there with my finger and did not solder it on. Thank you, I will send the email a little later. I do appreciate all the help from everyone!

Thanks for the tip, here is a better picture.

I just tried to jump it with a wire just to test it and I still did not get any lights or response.

Hope this picture is good enough because my phones camera isn't the greatest at a close up pictures if not I can try and find my camera.

I'm guessing that would also stop it from send a response back to the duet when should trigger the z stop, is that correct?

Not at all especially not from I was testing to the following day when it stopped working. It just weird.

Looking at it again you are correct. There is an outline and solder on L1 but no component.

On one side of L1 it reads 3.3v and on the other about 58mv and across C3 I read about 58mv as well.

Oh sorry, here it is naked. Lol

It was purchased on 2/1/2024 from printed solid. I just took it apart and only the connection to the duet board and still same results. Here are the pictures of it.

I sent the command and it did not flash at all. I had tried that earlier as well but got no LED response but in the console it looks like it was successful.

I have added the leading 0 to the config with no change and here are the resultsM122_Results.txt

The M98 p"config.g" returned

M98 P"config.g"
HTTP is enabled on port 80
FTP is disabled
TELNET is disabled

Yes I did check all the way through the pins. The only LED that doesn't light up at all is the green one for the z probe. All other LED lights do work perfectly fine, which is why I'm so confused.

Here is a picture of the wiring.

Thanks for the reply's I have updated the DWC version and still have the issue. I do not get any flashes from the LED on power up at all. Here are the config and home files. Thanks again for all the help!

homedelta.g config (4).g

I bought a smart effector to go with my Duet2 wifi board about a year ago but due to a new born I never got around to putting on my delta printer. I finally got around to it this past weekend and I got everything configured but now all of a sudden the Z Probe is not being detected. I am running RepRap 3.5.4 with WiFi server v 1.23 and Duet Web Control 3.4.6. I try to manually tap on the Smart effector and the LED does not light up anymore. Yesterday I was able to do a mesh compensation and an auto level with no issue but now it wont work at all. The fans, hotend, and thermistor work fine it just seems to be the z probe. I have checked all of the wiring and everything is solid. I am getting 3v, ground and all wires have continuity from end to end. I dont know where to go from here since it was working yesterday and now it is not.