Thanks for the follow-up. The one picture was taken before and one after but I just held the wire on there with my finger and did not solder it on. Thank you, I will send the email a little later. I do appreciate all the help from everyone!

Thanks for the tip, here is a better picture.

I just tried to jump it with a wire just to test it and I still did not get any lights or response.

Hope this picture is good enough because my phones camera isn't the greatest at a close up pictures if not I can try and find my camera.

I'm guessing that would also stop it from send a response back to the duet when should trigger the z stop, is that correct?

Not at all especially not from I was testing to the following day when it stopped working. It just weird.

Looking at it again you are correct. There is an outline and solder on L1 but no component.

On one side of L1 it reads 3.3v and on the other about 58mv and across C3 I read about 58mv as well.

Oh sorry, here it is naked. Lol

It was purchased on 2/1/2024 from printed solid. I just took it apart and only the connection to the duet board and still same results. Here are the pictures of it.