@dc42 Thank you for catching that I corrected M305.
I found the cause of my problem, the heat block was tight against the heatsink. I went back and looked at the Titan Aero assembly instructions and saw a picture of it ( Thank God for pictures).

They should put something in their instructions for dummies like me.

Everything auto tuned perfectly and have it set up in the firmware.

Now on to the rest of the setup, Thanks for being here for us newby's

Sorry I didn't type that correctly.
M303 H1 P1 S240

M303 H1 S240 Firmware version is 1.20

@phaedrux I do have a sock on it and no part cooling fan yet

This is what is in the heater section of my Config.g file ; Thermistors and heaters
;*** You can use S and B parameters to define the parameters of the thermistors you are using
M305 P0 T100000 B4388 R4700 H0 L0 ; Put your own H and/or L values here to set the bed thermistor ADC correction
M305 P1 T100000 B4725 R4700 H0 L0 ; Put your own H and/or L values here to set the first nozzle thermistor ADC correction
M305 P2 T100000 B3974 R4700 H0 L0 ; Put your own H and/or L values here to set the second nozzle thermistor ADC correction
M301 H1 P10 I0.10 D100 T0.50 S1.5 ; PID settings for extruder 0
M301 H2 P10 I0.10 D100 T0.50 S1.0 ; PID settings for extruder 1
M570 S12000 ; Increase to allow extra heating time if needed
M307 H0 A199.0 C962.6 D4.5 B0
M307 H1 A406.3 C166.4 D10.3 B0

I am pulling my hair out with this and sure it must be something wrong in the gcode. My hotend does not heat up vast fast therefore i get "Auto tune cancelled because target temperature was not reached". I have checked the heater cartridge it is 4.3 ohms which according to my searches is correct. I have 12.3 volts constantly to the cartridge.
My thermister matches within 2deg of the reading from my Klein meter and thermister.

I have even tried another heat cartridge and thermister with the same results.

Could someone please enlighten me as to what Iam doing wrong. I have Googled and read until my eyes are poping out.

Any help in a direction to fix this would be greatly appreciated.

Thank you in advance

I am sorry, I figured it out today. My lead screws were way out of adjustment and binding the build plate.
All stepper motors work good. Now on to getting the end switches working lol.

Sorry to take up your time.

I am using a Duet wifi, upper right corner of the wiring diagram it says Drive 2 then you have option A - 1- Z motor and Option B- 2-Z motors in series .

Hold on I just noticed the wiring color connections on the board are not the same as on my steppers. Let me change that and will get back to you.

Thanks