@jay_s_uk Thank You! I'll try.

The magnet mounted on the bottom of bed.

@jay_s_uk said in How to setup the new Z axis height?:

right, but the question still stands. how do you home z now? you must have a z endstop somewhere

I have the magnet Z endstop switch.

My Home X,Y,Z axis working now correctly. But I wish to lift the bed - I'll put a glass on the bed and I need the new height.

Hello, I would like to put on my 3D printer's bed the new borosilicate glass piece with 3.9 mm height. I haven't Z probe and I wish to lift Z=0 for 3.9 mm manually. How and where I can do it in the Web Control panel?

@nhof said in Is the M584 command's writing sequence important?:

@army61 That is correct.

So you would need M584 X0 Z1 Y2 En ; E can be 3 or 4

X motor would be plugged into the 'x' labeled output
Z motor would be plugged into the 'y' labeled output
Y motors would both be plugged into the 'z' labeled output

If you don't get enough power from the single Y output for both motors, you can use the extra extruder driver for the other Y instead, something like so:

M584 X0 Y1:4 Z2 E3
In this case the other Y motor would be plugged into 'E1' and the extruder 'E0', the rest of xyz would be standard mappings and match the labels.

It's fairly important to explicitly map each driver to an axis if not using the stock settings.

Thank You!

@fcwilt said in Is the M584 command's writing sequence important?:

@army61 Well the two Z connectors are electrical connected, either in series or in parallel.

So if your Y axis motors are always going to move in sync you can use the Z connections.

In that case the M584 command would simply be X0 Y2 Z1 E3, assuming you only will have one extruder.

On the other hand if your Y axis motors need to move independently then you will NOT be able to use the Z connectors.

I have no idea if the order is important. I have always used the order X, Y, Z, E.

Frederick

Thank You! Is it right - If both Y motors working in sync, then for the two Y motors will be for the one motor driver "2"?

I have one X axis motor, two Y axis motors, one Z axis motor and Extruder motor. The Duet Wifi controller have two Z axis motor contacts. Logically, my two Y axis motors need connect with two Z contacts on the board and via YAT Terminal run the comand "M584".
Which one would be right:
A. M584 X0 Y2:3 Z1 E4
B. M584 X0 Z1 Y2:3 E4
Is the command's writing sequence important? Priority is X,Y,Z,E or drivers: 0,1,2,3,4...

@stephen6309 Thank You so much!

@army61