@dc42 It worked 
finally I am setting up the axis etc. hopefully tommorow I will start my first duet print
Latest posts made by Magnusjen
-
RE: Duet wifi Controller interface won't accept passwordposted in Duet Hardware and wiring
-
RE: Duet wifi Controller interface won't accept passwordposted in Duet Hardware and wiring
Waaait a minute... I am in bed now and was just thinking cant i just take the SD card and configure IT without password?
-
Duet wifi Controller interface won't accept passwordposted in Duet Hardware and wiring
I got my replacement duet wifi board because the other was defective (yay)! I went through the whole setup again and put in the config file. But wanted to reconfigure it, when I did this it asked for the password. I gave it the password and then another million times and it refuses.. So I tried connecting with USB and via YAT change the password using M551 Pnnn but this didnt work either. I have tried looking around the forum, but you put "wifi" and "password" in the same search and it is cluttered with other searches..
So, basic question is, how do I gain access to the interface when it won't accept the simple password I gave it?
Best regards
Magnus -
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@dc42 Thank you for your assistance, hopefully I can get the next to function and can post more interesting questions
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@dc42 Hi, that is an amazing offer! I bought it Friday last week (2019.03.08) from RepRap.me in Denmark, they are one of your vendors in Denmark and I could not imagine them selling a knock off.
How do I go about the warrenty replacement?
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@elmoret Hi there, here is a picture of the board from above, if you guys need it I can unplug everything.
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@dc42 Thanks for replying, you got the situation right, I will upload a picture of my board aswell as another guy commented.
The extruder heater heats up fine, I checked both at the nozzle "to see it was just an IT lie" and DWC reports the heating. I have taken a screenshot of my DWC.
I would be happy if whatever mistake I have made can be corrected, you guys have made an awesome board.
I could not also add the picture of my board, I will do it as a reply to the other guy
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@tenjin Hi there, no I don't have an LCD and I have nothing going into the 10 pin connector.
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@veti Well, sounds like I will just wire my old control board up if that is the case and wait for new electronics parts to arrive and the perfect day to sit super calm and solder it on.
But good to know there is a fix, I will just wait for DCs comment.
-
RE: Attempt to move motors when VIN is not in range DWC shows 0.5Vposted in Duet Hardware and wiring
@genghisnico13 Yeah... I have lost hope, I am just waiting for someone to confirm it is dead.. I will take it as an expensive lesson in basic wiring.