Hello.
I think that on Dashboard/Extrusion Control
"Feed amount in mm" and "Feedrate in mm/s: " default data will be 5 and 5.
Now is 100 and 60 - in my opinion it is not safe and not good.
Can I save other default value in RC6?

Thank you. But I can not compile it.

Thank you for your response.
I have 1.23.2 firmware.
I see DIM option but need set dim to a lower brightness level or preferably completely turn off lighting.
Is it possible to control it?

Hi.
How do I set the panel to turn off the backlight automatically, for example after printing ?
Is it possible to send some g-code to the backlight settings to the panel? (panel 5" integrated).

Thank you for your response. It's a good idea.
It works. In config.g I wrote:
M581 T2 E0 S0;

and in
trigger2.g :
M80 ;
M581 T2 S-1;
M581 T3 E0 S0;

trigger3.g:
M81
M581 T3 S-1;
M581 T2 E0 S0;

There is one drawback to this solution.
When the M80 or M81 is executed in a different way, eg via Web or g-code printing, the button must be pressed twice.
Thank you for your help and I will be grateful for other suggestions.

Hello.
Has something changed in this matter?
I have the same problem: I need to turn on and off with one button (not stable).
Or maybe it is possible to write a macro to make some g-code depending on the result of checking another g-code?

Hello.
I think that on Dashboard/Extrusion Control
"Feed amount in mm" and "Feedrate in mm/s: " default data will be 5 and 5.
Now is 100 and 60 - in my opinion it is not safe and not good.
Can I save other default value in RC6?