@nitrofreak I realize I need to improve my print surface. I did not know if there was an easy way to increase the points as I improve my build. Right now I am only printing with a 1 mm nozzle , but I have a 300 W heater that can use 2.75 mm nozzles, I am going to switch soon. What layer height would you recommend for a 2.75 mm nozzle diameter?

Hello, I am new to the forums and I am trying to build a printer with a very large bed (~4x8 ft). I am using the Duet Wifi 2 with the 2.04RC1 RepRap firmware. Everything is working fine with the large bed I just need more resolution in my height map so the nozzle can interpolate better. Would this be possible? Thank You!