Topics created by smp433

@smp433 said in Possible increase possible 441 points for bed mesh compensation?:

@nitrofreak I realize I need to improve my print surface. I did not know if there was an easy way to increase the points as I improve my build. Right now I am only printing with a 1 mm nozzle , but I have a 300 W heater that can use 2.75 mm nozzles, I am going to switch soon. What layer height would you recommend for a 2.75 mm nozzle diameter?

Depending on the resolution i would recommend a 1.4mm layer height.
I have some experience printing with a 2.5mm nozzle. i printed that with a 0.35mm layer height, primarily for a stronger layer bonding. Works really well.
With a 1.4mm layer height you have a lot more room for first layer height error.