Hello,
i would like to get a interval beep output when the filament at the filamentsensor goes out at my Duet Wifi with a PanelDue7‘.
Is it possible to stay in pause.g with interval beep until i confirm a message at panel due?

Hello,
where i can buy actually one magnetic sensor in germany?

Micha.

@oliof did you know the measurement of the pitch?

@Veti Thanks a lot. Thats what i am searching for.

I need a new heatsink for the smart effector. Where can i get one as a sparepart? Maybe in a german shop?

I will retry as follows:
Make a correct setup for one effector and download all configuration files as a .zip.

Then i modificate the settings for the second effector and download this settings as a .zip.

So i can upload the .zip file to the board depends on witch effector i will use.

Could this way be work. What do you think about it?

Thanks for the reply, so far.
I think the only dimension differences of the effectors are the z-hight.

Is this a problem for the auto- delta calibration?
Must i do one calibration for each effector? Or can i calibrate one effector and the software correct the calibration for the other effector with the other z-offset value?

Hi,
i´m Micha. from germany an use a duet wifi board on my modified Anycubic Predator.

Actually i build up two smart effectors, one with an e3d hotend, one with a volcano.
Now i will change the effectors in depends of the printjob i want to do.

What is the right way to realize this with the duet reprap firmware?

Must i use the tool funktionality for this? Or must i hold two complete sets if configuration g- files und change them in the root if i change the effector?

Greets,
Micha.