@dc42 This is my aproach. I am close to receive my second smart effecto and plan to have also a vocano setup and a v6 setup.
But I was planning on using sets of filament named
PLA-v6
PLA-volcano
and set everything on the config file of each filament with a proper G30 setting.
So when I change the tool, then I must change the filament to the proper one, and I hope the config file runs the height change and the bed calibration (not sure yet to use S4 or S6)
My concern is, if I leave the filament set on tool, turn off the printer and turn it on, it should run the config.g of that filament when I start the print?
