@jay_s_uk
Thanks much, I am very stupid 
Lada
Best posts made by ladal
-
RE: M672 set sensitivity smart effector not workingposted in Smart effector for delta printers
Latest posts made by ladal
-
RE: M672 set sensitivity smart effector not workingposted in Smart effector for delta printers
@jay_s_uk
Thanks much, I am very stupidLada
-
M672 set sensitivity smart effector not workingposted in Smart effector for delta printers
Hello,
I have two versions of smart effector "v2 and v4", I have the same problem with both.
To set the sensitivity, only the example "M672 S105:50:205" works and returns the setting "M672 S105:205:50".
The sensitivity changes and the LED flashes 5 times.
If I try to change it to a value other than "50" or "205", no change is made, nor does the LED blink. Diagnostic and reset commands work correctly.Thanks in advance for your answer
Lada
-
RE: M591: Remote ports not yet supported by this commandposted in Firmware installation
Thanks much for reply, I wait for version RRF 3.02
Its super HW for control 3D printers.Lada
-
M591: Remote ports not yet supported by this commandposted in Firmware installation
Hello,
I build config for new corexy printer with Mainboard 6HC + Expansion 3HC + SBC on DSF 1.2.5 & RRF3.01RC5 & DWC 2.07.
I use this command for 2pcs filament sensor connected on 3HC board input io0.in & io1.in
"M591 D0 P3 C"1.io0.in" S1 R70:130 L24.8 E3.0"
"M591 D1 P3 C"1.io1.in" S1 R70:130 L24.8 E3.0"
What is correct result, for this problem, please?Thanks for reply
Lada