Never mind it was that simple. It worked and I’m connected.

Is the firmware folder hidden?

I get an error M997: file 0:/firmware/duetWi-Fiserver.BIN not found

Hello. I’m having trouble using Wi-Fi and connecting to my duet after going from the latest version of 2.05.1 to 3.0. The firmware upgrade went well, but after it was finished, the console on the paneldue gives a message of connected. Yet it is not connected, and I cannot find it on the network. When looking for the network info, I get a message saying another SPI transfer is pending and cannot even look at the information. I have tried fallback methods such as dropping the Wi-Fi binaries into the/SYS file, but apparently they’re not in the place they need to be. Any help would be appreciated.

@dc42 Update. Switched out the daughter board for another one I purchased from filastruder and it works fine. It must be the board.

@dc42 I’m using the phone application. Every time I try to attach a picture it just says undefined.

@dc42 yes

Also curious, if the channel 1 on the daughter board is “spi.cs1”
And you have one daughter board with the two ports, then is the second port for the same card “spi.cs2”?

I also have 3 PT100 cartridges in the same room measuring within 1° of each other. By that I mean looking at a PT 100s resistance table and measuring each one’s resistance, according to the table they are within 1° of each other.

On my precision bench meter both resistors measure R1-199.50 and R2-199.52