@64bit This worked amazingly thanks!

@64bit This worked amazingly thanks!

@jordna-le1299 said in Duet 2 Locked out of WIFI:

Earlier today I was trying to update from RRF2.05 to RRF3.0. I used DWC1 to upload the zip file with no luck. I then tried to use M997 S0 with the firmware with also no luck. Now when I start the duet there is no wifi page and it seems the wifi module is stuck. Here are the logs on YAT. I was wondering if anyone could help me because now I am locked out of the duet. Did I somehow corrupt the firmware? If so can I reinstall it?

To add onto it I have tried the sd card of a different working duet and that also did not work on the board. This leads me to think it is firmware related.

Earlier today I was trying to update from RRF2.05 to RRF3.0. I used DWC1 to upload the zip file with no luck. I then tried to use M997 S0 with the firmware with also no luck. Now when I start the duet there is no wifi page and it seems the wifi module is stuck. Here are the logs on YAT. I was wondering if anyone could help me because now I am locked out of the duet. Did I somehow corrupt the firmware? If so can I reinstall it?

Hi I was looking around the forums and I can't seem to find a comprehensive guide of downgrading the firmware. I want to downgrade the firmware for testing purposes. It seems to output this error each time I upload the firmware

Error: M997: In-application programming binary "Duet2_SDiap32_WiFiEth.bin" not found

Is there a way to get around this?

Ah so yea, so we're building a multi-axis printer. The problem here is that all the pins for that specific expansion board we're using are being taken up by servos. This is where my external board comes in, it has it's own driver and controller built in to drive an axis motor, and can be controlled by an external master using step and direction. Is this possible with duet, to just output step and direction from those lcd pins (STP/DIR (10 and 11))

Hi, right now I have an external driver that can take a step and direction output from a controller board like a Duet. I'm using a duet 2 ethernet and I see that there is a step an direction channel coming out of the lcd pins. I was wondering how I can get those to output step and direction either through the the web_ui or other methods. Thanks!

@dc42

You could specify the button height as the trigger height of the probe, then it would be taken into account automatically.

would this be done through the G31 command in config? Also to trigger it would I use the single z-probe command (G30)

I don't think the Z probe last stop height is currently stored in the OM, but I could add it.

Through a firmware update?

@dc42 if I wanted to store the offset and use it as a variable instead how would I do so. The reason why is because rather than the button being at the bed it would actually be at some known height above it. Therefore I would be able to use that number and offset it from the true height.

@jordna-le1299
Ok so I got the z-probes to work independently now. However, now when I probe and store into a point (P0) where can I use this value to put it into my nozzle offset?

@dc42 I am currently using RRF 3.1.1