@dc42 some manuals how to calibrate S value? I have best results with M309 S0.03 (lowest temperature fluctuation by extruding the same amount of filament (PETG 235 degrees) on same speed G1 E60 F200).
Best posts made by Del87
-
RE: PID Tuning With Filament Flowing (heater feedforward M309)posted in Firmware wishlist
Latest posts made by Del87
-
Wrong percentage of completed workposted in Beta Firmware
When using M226 for the filament change there are some time and some amount of filament used, which are eventually involved in calculating the percentage of work performed. Displays 100% even though only 2/3 of the work is done. I guess time on pause and dwc driven filament while paused should not be included in the count.
Duet 3 mini 5+ firmware 3.4.2rc2 -
RE: Weird macro behaviourposted in Gcode meta commands
My observations regarding macros:
M83 via console works.
Makros file containing one string M83 not working. -
RE: Software bundle 3.4.1RC1 now availableposted in Firmware installation
@dc42 typo in changelog
M952 nonlinear extrusion (must be M592)btw it is possible to add more decimal places to the A coefficient?
-
RE: RRF 3.4.0 Sensorless Homing Issues after Power Cycleposted in Beta Firmware
@flobler mb because stealthchop is not default mode on 3.4 anymore
-
RE: PID Tuning With Filament Flowing (heater feedforward M309)posted in Firmware wishlist
@dc42 some manuals how to calibrate S value? I have best results with M309 S0.03 (lowest temperature fluctuation by extruding the same amount of filament (PETG 235 degrees) on same speed G1 E60 F200).
-
RE: 3.4.0RC2 and 3.4.0RC2+2 driver stall warningsposted in Beta Firmware
@dc42 yes but 1 or 2 warning looks not so scary as a lot of on the first screen.
-
RE: 3.4.0RC2 and 3.4.0RC2+2 driver stall warningsposted in Beta Firmware
M915 X H200 S1 R0 F0
M915 Y H200 S1 R0 F0
(instead of R1)
allows me to print without warnings and i hope/guess without underruns.Such a solution is correct when using only sensorless homing or still there is some underwater rocks?
-
3.4.0RC2 and 3.4.0RC2+2 driver stall warningsposted in Beta Firmware
On firmware 3.4.beta6 no warnings, Underruns [0, 0, 0] with sensorless homing and all printing time.
Current firmware 3.4.0 RC2+2 (but same was on 3.4.0 RC2) there are underruns [0,0, "some low digit"] and a lot of messages of drivers 0 1 (X Y motors) at the print starts. It is not affected to print quality, no layer shift etc. One time it makes one motor not working untill i reboot board but i am not sure (there was some testing with sensorless homing repeatability and i am not advice anybody to try sensorless homing on full steps).
So G28 in gcode - errors message (sometimes a lot of), G28 via console - no error messages. Is it error or just normal done of sensorless homing dunno.
Config and homeall attached:
config.g
homeall.gDuet 3 mini 5+ board