@Phaedrux
I have reached out to the dealer but are there any forms I need to fill out for duet Directly or will the distributor take care of all of that ?

@dc42
I went through and disconnected all of my USB cables and hubs from my pc. I then went and removed any un used USB devices in the Device manager. I then restarted the pc but It still won’t show up on device manager Even after scanning for hardware changes.
Also like you suggested I went through and tried all of my USB ports both on my pc and on my Mac but it still has the same problem.

@Phaedrux
I just went though and tried your suggestions but still same response unfortunately.
I ordered it from my local distributor in Melbourne, aurarum . I ordered it on Aug 16th

@Phaedrux
This is just with out the SD card

@Phaedrux

@Phaedrux
I’ve been installing the jumper powering it on for 20sec ,then powering it down and removing it before plugging it back in to USB

@droftarts
Yes, sorry that what I used I was just typing this on my phone and it’s not on a icon on my phone keyboard

Hi @Phaedrux
Yes I have bossa on my pc and it doesn’t show up as a port, I’ve tried a handful of cables with and without a USB 2.0 and 3.0 hub
I also Duplicated it on my Mac, using (Is /dev/try.*) to check ports.
It still just shows the diag ,USB, 3.3v, 5v leds

@bearer
Yes I’ve been through the connection troubleshooting post and I have verified my USB leads with an arduino but when I connect I still get the diag led stuck on along with the 5v and the 3v led

Hi @all

I’m new to the duet platform, but I have been impressed with the functionality it provides to my old tevo little monster. That said I have run into a problem while I was setting up the board.
After setting up the board with the reprap online config, I had to reset the wifi at my router to set the printer to a static ip.
After doing this I was un able to connect via wifi so I plugged in the USB and it wouldn’t show up in my device manager.
I disabled the wifi module via the config.g on the sd card and reset using the jumper but it’s still not visible in the device manager.
Is there anything else that I should try to try and re established a coercion ?