Hi,

For a big volume 3D printer design, I research a people able to advise me on the multiples aspects to the Duet3D systeme. If your are french and if you know very well the Duet3D système, I have many interrogations and problematics.

a huge thank you !

Rodrigue

hello,
I'm actualy running this firmware and I am unable to update it. Attached the issue.

Thanks for your help,
Rodrigue

@MintyTrebor
Thanks for your help.
Can I ask this fonctionnality for futur versions ?
It will be so nice to custom correctly our owns interfaces.

@T3P3Tony
Exactly. I use btn pluging to bluid my own interface.

Hello,
I want to change the color of a btn button following viarable value. Someone know how to do to it ?
For exemple, if the door is close, global.closedoor = 1 => the button "close is gray"

if the door is open, global.closedoor = 0 => the button "close is red"

@dc42 Thanks for your quick reply !

Is it possible to a standalone display sensor value ? On custom menu of course.
As MCU temp or vin value like this

Thanks

I want to show the value to this sensor on dwc.

M308 S2 A"Eau" P"temp1" Y"thermistor" T10000

Thanks everyones.

Rodrigue

Hello,
I use a air pump with proportional valve to make the piece cooling. So i need to know how to use servo position as fan speed. I work with prusa slicer. If a tips exit to custom the tool fan gcode, i'm so interrested a well.

Thanks for your help,
Rodrigue

@Phaedrux
I'm running 3.4.4 firmware version.

I want to use the filament sensor as input for close the enclosure door.
I've no filament sensor on pin e2stop, there is my door sensor.

M106 P1 S1 run a pwm fan to 100% for powered an electric magnet
through a DC static relay .

Hello,
I want to execute "trigger2.g" when e2stop rising.

Config.g

M591 D2 P1 C"duex.e2stop" S0
M950 J2 C"duex.e2stop" ; Configurer la broche GPIO pour le capteur
M581 T2 P2 S1 R0 ; Surveiller la broche GPIO J2, déclencher la macro 2.g lorsqu'elle passe à l'état haut

0:/sys/trigger2.g

M106 P1 S1

The trigger work when i send M98"0:/sys/trigger2.g" but not with E2stop value

Thanks

@Alex-cr
Amazing job ! Tanks for your help ! I'll try to make a similar code for my config. If I have any difficulties I will contact you in pv.