Hi @aldiallo
I'm getting down the configuration.

But at the moment, I'm stuck with 2 problem :

1. the BLTouch is in error directly when switching on the duet...
   Last time I used the ender with the creality board, it was working fine...
   Did you got that too ?

2. Heated bed not heating up :
   As read above, and said by @Phaedrux I took out the creality mossfet .
   Wired the 24V power in the VIN and connect my 24V bed directly on the OUT0
   Should I double the wire to OUT0_input from the same power station ?

@aldiallo Thank you for the sharing and the infos.
I'll take attention to the difference.

At the moment, I'm using a stock ender 5+ and I want to fisrt setup the duet with this configuration before going on other mod.

I didn't find other user with stock ender5+ (only 5 and 3)

I also got a lot of issue understanding the mesh compensation en duet 2 with the homemade printer at the point that I switch back to an optical endstop.

I'll let you know.

Hello there,

I'm upgrading to my creality ender 5+ with the duet 3 6HC.

@aldiallo
Are you done and ok with the configuration ?
If yes, can you share with us your last config ?

Thanks a lot.