@dc42 Thanks

I installed a duet 3 mini 5+ on my ender 5 and set it up with klipper. both my stepper motors and stepper drivers get hot enough to burn me and I think are missing steps because of it. I have the run current on all my steppers set to one in klipper. the duet 3 mini 5+ is capable of over 2A per stepper driver, while I'm running mine on 1A and even with oversized heatsinks on the steppers they get incredibly hot. Aswell my steppers are very loud. Here's me config
[tmc2209 stepper_z]
uart_pin: PA1
tx_pin: PA0
select_pins: PD0
uart_address: 2
run_current: 1
hold_current: 0.2
sense_resistor: 0.056
stealthchop_threshold: 999999

I'm not sure if changing the sense resistor value could help, I tried changing it for one stepper and while changing the sense resistor value to 0.150 or 0.120 did change something, it seemed to run different and stutter on smaller/slower movements.

@phaedrux Thanks for all your help, I did finally realize something that was quite confusing. the 5v select jumper you mentioned is labeled as such on the silkscreen on the board but in the board diagram image that you sent as well as the ones from setup tutorial's it is labeled as 5V source. Not sure why I didn't connect the 5v select you mentioned and that I finally saw on the board and the 5v source pin diagram I looked over quite a few times. Again, thanks for all your help with troubleshooting and have a nice day

Sincerely,

Thunder

@phaedrux I just checked the fuse isn't blown. thanks for the suggestion though

@phaedrux Thanks for your help, I appreciate it . have a nice day!

@phaedrux Also I have some buck convertors handy if I need to power the 5v rail externally

@phaedrux

@phaedrux I bought it from filastuder in the second half of may. the only jumpers on the board are the two that select 24 or 12v output for out3/4 and out5/6.

I just bought a duet 3 mini 5+ for my ender 5. I got all the wiring setup and connected to the board over USB and got it set up to my network, when I tried to power it from the printers 24v PSU the 5v led didn't turn on and it wasn't showing up on my WIFI. The DWC online network interface works if its powered via USB but not if its powered from the PSU. I found some information about a 5v select jumper but can find it on my board. Thanks in advance, Thunder