@droftarts Thanks again the fan is up and running. I ended up connecting the ground to io0 ground and the three pins from the the fan to PWN, Tach, and 12v.

@droftarts Thanks again the fan is up and running. I ended up connecting the ground to io0 ground and the three pins from the the fan to PWN, Tach, and 12v.

@droftarts Yes it is a 1LC v1.1, thanks for insight.

Hey everyone,

Quick question: I'm trying to hook up a 4-pin fan to my tool board, but I only have a 3-pin port available (20.out2). I'm thinking of wiring the PWM, Tach, and 12V from the fan to 20.out2 and then grabbing a ground from a different port. Anyone see any issues with this? Or have a better solution?

Thanks!

@alex-cr Thanks for the insight.

Hi All, sorry for the noob question, I am upgrading from the Bondtech clone to an official LGX in the bowden configuration. My question is, are your numbers based on the direct drive configuration, or does it not matter? Thanks.