so i've to do the update that i planned first.

• Problem was that i started the G29 code but a cold blob on my nozzle touched the bed first and the Z kept forcing down.
  (BL touch should also fix this but i've not recieved is yet

Hi,

I would like to prevent my Z axis to home cold
Can i add a condition that the temperature of the nozzle has to be between temperatures without actually changing the setpoint?

Hi,
i am looking to change my printer so i can easely take off my direct drive printhead and put another direct drive printhead in it's place (to experiment with dual extrusion laser engraving toolhead etc in the Future.)

How can i configure my duetwifi firmware in order to select thé installed tool (i guess in Silver), in which the duet uses the respective settings for that tool?

@bearer that worked, thanks man.
Board is over a year old now, so na waranty there.

@bearer it does start up from USB, what al i looking at?

@bearer yes i did

Ik have my 12v 350w ATX PSU connected to my duet2wifi
Therefore i connected thé 12v cables to thé main power supply,
Thé purple cable to thé 5v_in thé green to thé ps_on and connecteda gnd. (All 3 on thé pins next to main power supply)
Then i switches thé Jumper tob external 5v_in.

Ik do measure 5v between 5v_in and gnd but thé board (wifi) does not start up

If it short between ps_on and gnd, thé 12v does start up thé board (but not thé wifi since they Jumper is mover)

What do it miss here?

Hi, i'm looking for a 24v pcu solution that can be combined with thé ATX function on my duetwifi.

@SIam can i specefy witch network to forget?
Of wil it erase all networks?

Hey

My Original connected network to my duet wifi board seemed too week so i installed a repeater.
Now i want to remove thé original network connection and only keep thé repaeted one.

How can i do this?