@adavidm, thank you very much, I have formatted the card and put back a backup that was old and has returned to work.

@adavidm, thank you very much, I have formatted the card and put back a backup that was old and has returned to work.

My core x and is working perfectly. Today when I tried to load a g-code I get this error message. I have no way to load any file and the card is not full, it has nothing.
You know how to solve it. Thanks.
Error: Failed to write to file. Drive may be full.
Error: Could not write upload data!
Error: Failed to delete file 0:/gcodes/pieza 2.gcodeuet 2 wifi.
Firmware version 1.21.
0_1538396003540_config.pdf

I can not calibrate the retractions of my cyclops e3d in any way, there are always the typical threads. I'm crazy changing all the possible configurations in both simplify3d and Duet. I have an extruder Bondtech. I could pass someone who has cyclops, Bondtech, the SF3D settings and acceleration, speed and jerk in Duet if it works well in retractions?

Thank you both, now I can.

Is there any way to change port 80 to be able to access from an external network to a wifi duet ?.My problem is that I have 3 duet wifi and I can only access one of them by forwarding ports and I do not know how to put the others.
Is there any way to change port 80 in the other wifi duet ?.

ok, thanks.

thank you very much, I will look for it because my web version is the last and I save myself to start

Is there any way to recover the config file when it is accidentally deleted or do I have to start over again?

I would also like to buy some sensors for my 3 printers, I have 2 deltas and a core xy with 3 duet wifi and it is a complement that I think is essential for long impressions. Thinking about the quality of their products, this sensor will be wonderful. I hope news.

thank you very much, Dougal1957.