Topics created by andrewe

@bearer It could have been a bit longer but I tested for continuity between each leg and the pads on the front and back the best I could. I'm going to try and hunt down a spare wifi module just in case 👍

To be fair the bed is pretty shabby It was an Anet A8 and came bent from new. The bed, 1x end stop and the motors are all that's left now. I have a feeling its too out of true even for mesh compensation but I can see that working watching the z screws constantly moving.

I use a Prusa spring steel sheet with PEI on it, all held in place with magnets and bulldog clips.

I've got a new bed on its way in the post next week but I know how to set the probe up now thanks to yourselves. I think I'll look at different probes and try and get it as close to the nozzle as I can.

Thanks for all your help
All the best Andy

0_1542915137648_i3.jpg