@pkos said in Duet Web Control 2.0.0-RC4:

Every layer change, I get:
Failed to maintain connection to printer.local
Cannot set property 'firstLayerHeight' of undefined

It's even worse when you want to print something in the vase mode. Then you get that error every second. It's very annoying...

I want to configure my printer to be turned off when max temp is reached by any of my heaters. I know that there is an A parameter in M143 command but what is the difference between A1 and A2?

@wilriker said in Configuring "resume a print after a power failure":

2. You have a way of reliably determining the Z position of your printer
   -> use G28 XY to only home X and Y and G92 Znnn where nnn is the current position of Z to tell the printer the current Z height without the need of the homing process for Z

Yup But I asked what parameters should I use. I need to know what Z coordinate was beore power loss.

Hi, I want to configure "resume a print after a power failure" option on my Duet but I have one problem with understanding documentation. It says that I need to use G92 command in sys/resurrect-prologue.g to tell the printer Z coordinate. But what parameters should I use?