Yes, it is a kinematic mount with ball screws. According to my logic, I wanted to use the "B" position too. Many thanks for your help
Best posts made by bernie-mix
-
RE: Set up three Z-axis location - M671posted in Duet Hardware and wiring
-
RE: motor phase A may be disconnected reported by driver(s) 5posted in General Discussion
Okay, I found out for myself why: In the M584, I incorrectly addressed the extruder stepper!
Wrong line:
M584 X0.3 Y0.4 Z0.0:0.1:0.2 E0.5correct line:
M584 X0.3 Y0.4 Z0.0:0.1:0.2 E20.0WOOHOOO - it works
-
RE: Set up three Z-axis location - M671posted in Duet Hardware and wiring
At the rear is a magnetic spherical recess, front right is magnetic v-groves (45° to X and Y axis) and front left a a plane round magnet