FWIW... I may have found the cause of my 'pausing' issue. It appears that it was caused by a short of some kind on the extruder stepper motor, on the duet side(?). I repositioned the cables around the stepper motor connectors on the duet side and so far have not experienced this issue.
I also want to add that in addition to the issue being intermittent, it was present whether the rotating sensor was enabled or disabled (so it was not a problem with the sensor or sensor config).
I took a video of what's happening while it's pausing.
Hello everyone,
I have been using the Duet3d filament monitor for a few weeks now. I started noticing that the printer is pausing mid-print and the pausing is not consistent nor is it lengthy (maybe a second or so, maybe less). Can anyone suggest what might be causing this? I double checked and didn't see anything in gcode that would add pauses (same gcode that i printed months before and didn't have any pausing).
I'm currently on v2.03 of the firmware.
Sensor output from M122 below
M591 D0
Can anyone suggest what might be happening and where do I go from here in troubleshooting this further? Thanks!
We were initially using G31 and switched to G10 on suggestion of a couple of members of Railcore team. What is the difference between the two in terms of accuracy and purpose?
Hello everyone,
A friend of mine and I recently observed some strange behavior relating to the Z offset. We both use G10 to set our Z offset from config.g and it generally works great. However, what both he and I observed was that whenever we either reboot the Duet controller or physically power cycle the power on the PSU the z offset ends up being off by some amount causing the bed to be too high or too low which means the offset has to be reset to 0 and re-measured.
I have a Duet2 Wifi with Duex5 board, my friend has a Duet2 ethernet with Duex5. I'm on Firmware 2.02(RTOS) (2018-12-24b1) he is on 2.03 (2019-06-13b2)
Any ideas what may be happening here?